If you've purchased an Android Register and want to set it up, look no further! This guide will walk you through the steps on setting up this Register.
Let's get started!
Set Up the Android Register and Built-in Printer
When unboxing the Register, take out the adapter and wire. Connect the small wire head to the port below:
On the bottom right of the device, you'll see the blue power button.
Turn it on by holding the blue power button for about 1-2 seconds.
Turn on the attached receipt printer by holding down the button on the right for about 3-5 seconds.
The green light (left) will appear, then the red light (right) will light up when powered on:
Once turned on, you'll see the main screen of the Android Register. Be sure to Activate your Register if you have not done so already.
Now it's time to set up the built-in printer.
Open the highlighted latch by pulling it down gently. Place your receipt roll so that the loose part is at the top of the roll.
Next, go to the StoreHub app on your Android Register.
Go to the Menu > Settings > Printer.
Toggle Always Print Receipt ON.
Tap Built-in Printer, then choose Receipt.
Tap the ellipses icon (...) and choose Print Test Receipt:
Your printer should print a test receipt!
Connecting a Cash Drawer
If you've also purchased a cash register and want to link it to your Android Register, setting it up is easy!
Take the RJ11 / phone cable that comes with the cash drawer and attach it to the port that says CASH:
Connecting a Barcode Scanner
Similarly, if you've purchased a barcode to be used with the Android Register, setting that up is easy too!
To connect the barcode scanner, attach the scanner to either of the USB ports found at the side of the printer (where the Power On/Off button is).